MAN#650177
avoid damaging the wire insulation.
7. Feed the wires through the larger hole in the mounting plate and guide it to the bottom of the
housing. The flat side of the mounting plate should be on the outside of the housing and the
side with the slight raised center should go toward inside of the housing. This will properly
align the mount in the original housing.
8. Now hold the LED assembly centered over the hole where the original bulb was and align the
mounting plate from the bottom with the slot in the housing. The screw holes on the LED
assembly and the mounting plate should be lined up.
9. Screw the mounting plate into the mount using the two previously removed 3/8” #6 screws.
This will secure the LED assembly into the housing. You are now ready for reassembly.
10. Place the original lens gasket into place and replace the tail light lens. Tighten the screws
down carefully.
