MAN #650687D
BIM-01-2-EDBK
Bus Interface Module for Edelbrock Engine Management
setup/status switch
BIM-01-2-EDBK
Bridge Module for Edelbrock Systems
www.dakotadigital.com
605-332-6513
INPUT
BIM-xx-2 power & data connectors.
Either one can be used.
BIM-xx-2 18 inch power/data harness
Connect directly to
another BIM-xx-2
Connect to the BIM-01-2
if you need to connect to a
BIM-xx-2
Connect to the
BIM-01-2
4 PIN CAN
connector
Adapter harness
This Bus Interface Module is designed to read engine information from specific Edelbrock CAN bus enabled EFI units
which currently includes: Pro-Flo 4 EFI system with v53 or later. The module is connected to the Edelbrock device main
harness through one of the adapter harnesses that are included within this kit.
There are two interface (I/O) ports on the module. Either one can be connected to the gauge system or to another
module, allowing several units to be daisy chained together. Do not connect the I/O port to anything other than a Dakota
Digital gauge or BIM. Do not mount the module in the engine compartment; it should be mounted in interior of the vehicle.
The engine and transmission information that is available from the unit depends on the Edelbrock module programming
and add-ons. The possible values are: engine RPM, engine coolant temperature, intake/manifold air temperature, fuel
pressure, A/F ratio, MAP and boost.
Available readings: engine RPM, engine coolant temperature, intake/manifold air temperature, fuel pressure, A/F
ratio, MAP and boost.
