PACKAGE CONTENTS
•
Receiver
•
Power adapter
•
User Guide
POWERING YOUR RECEIVER
1. Connect the power adapter to the bottom of the receiver, threading the cord through a groove in the bottom.
2. Plug the adapter into a power outlet.
Power adapter
Bottom
MOUNTING THE RECEIVER
Attach two screws (not included) or nails to your wall 6.7cm apart, then hang your receiver.
DELETING ALL SENSORS
1. Press and hold the
MODE
and
(volume) buttons for three seconds until the four lights flash slowly.
2. Press and hold the
MODE
and
(volume) buttons again for five seconds. The four lights flash quickly, then turn
off. The receiver is reset.
Note:
To relearn the sensors, see ”Setting up your receiver”.
3. Press (volume) repeatedly until you find the tune you want to use.
4. After you choose a tune, activate the transmitter (for example, press the key button or activate the motion sensor).
The receiver emits a short beep.
Note:
If you accidentally activate the transmitter on a tune you don’t want, press the
(volume) button to
continue cycling through the tunes to select the tune you want, then reactive the transmitter.
5. If you are coding more than one transmitter, repeat steps 3 and 4.
6. After your transmitter(s) are coded, press and hold the
MODE
button until the LEDs stop flashing.
7. To test the transmitter tune, activate the transmitter. You’ll hear the selected tune through your receiver and the
LEDs will flash.
ADJUSTING THE VOLUME
•
Press the
(volume) button repeatedly to adjust the volume (four levels and off). The lights show the volume level
for four seconds.
1
Ding Dong (high)
5
Alarm/Siren
9
William Tell
2
Ding Dong (low)
6
Coo Coo Clock
10
Cannon in D
3
Westminster
7
Bird Chirping
11
Morning
4
Fur Elise
8
Twinkle Twinkle
12
Toreador March
SETTING UP YOUR RECEIVER
Note:
You can connect up to 16 transmitters to your receiver.
1. Place your receiver and transmitter next to each other.
Note:
Be careful not to activate your transmitter until you find the tune you want. If your transmitter is a motion
sensor, consider covering the sensor to avoid accidentally activating it.
2. Press and hold the
MODE
and
(volume) buttons for three seconds. When all four LEDs flash, release the
buttons.
Volume
Mode
Speaker
LEDs
