24
English
Operation guide
1.
After putting through the power, press "
" button on remote controller to turn
on the air conditioner.
2.
Press "
" button to select your required mode: AUTO, COOL, DRY, FAN,
HEAT.
3.
Press "+" or "-" button to set your required temperature. (Temperature can’t be
adjusted under auto mode).
4.
Press "
" button to set your required fan speed: auto, low, medium and
high speed.
5.
Press the "
" button to select fan blowing angle.
Replacement of batteries in remote controller
1. Press the back side of remote controller marked
with " ", as shown in the fig, and then push out
the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
signal sender
battery
reinstall
remove
Cover of battery box
●
During operation, point the remote control signal sender at the receiving
window on indoor unit.
●
The distance between signal sender and receiving window should be no more
than 8m, and there should be no obstacles between them.
●
Signal may be interfered easily in the room where there is fluorescent lamp
or wireless telephone; remote controller should be close to indoor unit during
operation.
●
Replace new batteries of the same model when replacement is required.
●
When you don’t use remote controller for a long time, please take out the
batteries.
●
If the display on remote controller is fuzzy or there’s no display, please replace
batteries.
Note:
