Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
977102-1
16
REV112019
SYMPTOM
CAUSE
SOLUTION
Chuck or quills fall out
Rust inhibitor, dirt, debris in
or on quill or spindle taper
Clean chuck and quill
Table difficult to raise
Needs lubrication
Lubricate with light oil
Table lock tightened
Loosen clamp
Bent rack
Straighten rack
Spindle does not move up or
down
Belt is broken or slipping
Check belt for damage and
replace if needed
Debris in quill
Clean quill and teeth
Feed depth adjustment is set
See “Feed Depth Adjustment”
in this manual
Spindle does not rotate
Belt tension is too loose
Check belt for damage and
replace if needed
Belt is broken or worn
Replace belt
Taper is slipping in spindle
Clean chuck and quill
Motor is not rotating
Troubleshoot motor or
contact DAKE
