Dake LAGUNA 14CX, Instruction Manual

Page: 12 / 37

14CX 12 REV#072023
NOTE: The table has a reference stop bolt that is used to quickly align the table after tilting. The stop
bolt hits the tilt-blanking disc when it is positioned over the table tilt hole. When the tilt blanking disc
is moved away from the hole, it allows the tilt stop bolt to pass through the table tilt hole, and the
table can be moved to the maximum amount of tilt (-7 degrees).
9. Locate black plastic handle in hardware bag and use 14mm wrench to attach this
handle to the handwheel on the top right of the machine.
10. Remove plastic from table & remove protective oil on table top. Recommended:
WD-40.
11. Install the front fence scale, using 2 Hex Cap Screw (M5x0.8x10) to the upper
holes on the front of the table. Later when blade is installed adjust scale so 0 is equal to the
blades path.
12. From your hardware package, using x2 Socket Head Cap Screw
(5/16"-18x2") and x2 spacers. Attach fence rail to table using the
cap screw and stand-off bolts.
NOTE: Hole 5-1/2” from end should be on the left side.
13. Take fence knuckle and back-off the lock knob enough to fit it onto
the fence rail.
14. Aluminum fence may now be added to the fence knuckle. Fence can be
mounted high or low. To mount, loosen the smaller lock knobs on side of
fence knuckle and slide T-slot over the bracket on the fence knuckle. Lock
knobs when in place. Make sure fence is square
NOTE: If fence needs to be adjusted, nylon slider nut on the inside
of the casting to adjust fence up or down. There are also 2 set
screws on the side of the casting that adjust the angle of the fence.
Before First Time Start
1. If you are still not thoroughly familiar with the operation of the bandsaw, get advice from a
qualified person.
2. Make sure the machine is properly grounded and that the wiring codes are followed.
3. Do not operate the bandsaw while under the influence of drugs, alcohol, or medicine or if tired.
4. Always wear eye protection, safety glasses or a safety shield, and hearing protection.
5. Wear a dust mask; long-term exposure to the fine dust created by the bandsaw is not healthy.
6. Remove your tie, rings, watch and all jewelry. Roll up your sleeves to prevent catching clothes
in the saw.
7. Make sure that the guards are in place and always use them. The guards protect you from
contacting the blade.