__________________________________________________________________________________
20
To Measure Density:
1. Solid Mode:
Assumed that all the mechanical arrangements are with respect to solid mode you can start the measurement
by following the below steps:
Step 1
Step 2 (a) Step 2(b) Step 3
Step 4 Step 5 Step 6 (a) Step 6 (b) Step 9
1.
Hold the Solid sample by means of a Tweezers displayed in step 1 above.
2.
Place the weight in the
centre
of the upper cover like shown in the above display to measure the weight in
Air (Shown above in Step 2 (a & b)
(Suggest: When placing the sample get rid of the bubbles on the sample by shaking it slightly in water, as
bubbles might cause interference in the accuracy. Alt sample can also be washed in Ethanol before sinking in
water, as it is alright to sink the sample in water with ethanol remaining on its surface)
3.
Press OK & wait till aerial weight is displayed, press OK to proceed after the “
*
” appears on the display
readings.
4.
Remove the weight by using the Tweezers like in the above Step 4
5.
Open the Flap Cover to proceed to measure weight in Liquid.
6.
Place the weight in Liquid in the Centre space (shown in image Step 6 a & b)
7.
Press OK and wait till reading is complete, liquid weight is displayed, press OK to proceed after the “*”
appears on the display.
8.
Density & Volume results are displayed, press OK to continue, this transmits the data to printer & PC.
9.
Remove the specimen from the liquid using the Tweezers as shown above.
Caution: This is an electronic device and water spillage may cause its failure. When re-measuring the same
sample, dry it up again without fail.
Necess
