TR3 Front Lens Shell
Installation Guide
www.gecurrent.com
© 2021 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks of the
General Electric Company and are used under license. Information provided is subject to change without
notice. All values are design or typical values when measured under laboratory conditions.
RAIL159 (Rev 03/15/21) 99003749
Installation Steps
Lay down the lamp on a clean workbench
on its back shell to ensure no scratches on
the front shell. Remove the 4 top screws
and pull the front shell off.
Location pin
Using gloves, gently place the new front
shell on the back shell. Align the lens
location pin to the location pinhole on the
back shell.
The lamp is ready to be installed in the field as per Current’s installation instructions.
Verify that the black gasket is well seated
in the lens. If required, use your fingers to
push it in place.
Insert and fasten all four screws into the
front shell. (Torque between 4 and 5 inch-
pounds).
NOTE: Screw stripping or lower torque may
cause water to penetrate the lamp.
NOTE: Failure to properly follow these instructions may cause signal to malfunction.
Pictures are for reference only. Actual lens shape may appear different.
1
3
2
4