Installation Guide/Manuel d’installation
Lumination
®
LRXD
Gray
0-10V +
Violet
L
D
N
Ground
Black
Violet
White
Gray
Green/Yellow
Optional dimmer: When connecting with
dimming controller, wires must be run through
another separate knockout hole. Connect the
violet (d) and gray (dimming -) wires
to the violet and gray wires of the fixture.
Note: Please cover dimming leads with wire
nuts if you won’t connect with dimming leads.
Dimming compatibility for 0-10V, please refer to
Current’s website:www.gelighting.com/dimming.
Note: For 2700/3000/3500K model and 3500/4000/5000K model, the default CCTs is 3000K and
3500K respectively. Lift up the cover for the switch, and use it as a tool to choose the desired CCT.
CCT Setting Switch
Lift cover
up as a tool
Secure provided junction box to the building
structure or existing frame per local codes.
If necessary, remove existing junction box.
Connect AC conduit to provided junction box
and connect the black, white, and green/
yellow wires of the AC leads to the black, white,
and green wires using listed wire
connectors and close junction box.
6
Springs up
Load springs into upright position by twisting
the springs upward and carefully insert the
fixture to the hole of the frame. Verify the
trim is flush with ceiling.
7
Risk of personal injury. Operators shall ensure no appendages are in the path of the torsion springs as they are a pinch hazard when released. The springs will
release when the arm is flexed downward. Be cautious that no body part is in the path of the spring when released.
Risque de blessure corporelle. Les techniciens veilleront à ce qu’aucun appendice ne se trouve sur le chemin des ressorts de torsion, car ils présentent un risque
de pincement lorsqu’ils sont libérés. Les ressorts seront libérés au moment de fléchir le bras vers le bas. Faites attention à ce qu’aucune partie du corps ne se
trouve sur le chemin du ressort à sa libération.
CAUTION/ATTENTION
3
