Daimler Freightliner Cascadia 2021, Driver Manual

Page: 282 / 322

Ball Point Ink
Ball point ink can sometimes be removed if rubbed
immediately with a damp cloth, using water or rub-
bing alcohol. If this does not work, try the procedure
used for sulfide stains.
Miscellaneous
If stains do not respond to any of the treatments de-
scribed above, it is sometimes helpful to expose the
vinyl to direct sunlight for up to 30 hours. Mustard,
ball point ink, certain shoe polishes, and dyes often
bleach out in direct sunlight, leaving the vinyl undam-
aged.
Velour Upholstery Cleaning
To prevent soiling, frequent vacuuming or light brush-
ing to remove dust and dirt is recommended. Spot
clean with a mild solvent or an upholstery shampoo,
or the foam from a mild detergent. When using a sol-
vent or a dry-cleaning product, follow the instructions
carefully, and clean only in a well-ventilated area.
Avoid any product that contains carbon tetrachloride
or other toxic materials. With either method, pretest a
small area before proceeding. Use a professional
upholstery cleaning service when extensive cleaning
is needed.
Grease and Oil-Based Stains
Dampen a small absorbent cloth with dry-cleaning
solvent or spot remover. Apply the cloth carefully to
the spot from the outer edge to the center. Pat and
blot the spot with a clean, dry cloth. Repeat several
times, as necessary, turning the cloths so that the
stain does not redeposit on the fabric.
Sugar and Water-Based Stains
Apply water-based detergent or cleaner, working in
circular motions. Pat and blot as dry as possible. Re-
peat, if necessary, before drying thoroughly.
Chewing Gum or Wax
Harden the gum or wax with an ice cube wrapped in
a plastic bag, then scrape it off with a dull knife. Ex-
cess wax can be absorbed by placing a thick white
blotter over the wax and heating with a warm (not
hot) iron. Remove the remainder by using the proce-
dure for grease and oil-based stains.
Mildew
Brush the dry fabric with a soft brush. Sponge with
detergent, and blot. If the fabric is colorfast, dilute a
teaspoon of bleach in one quart (one liter) of cool
water. Apply with a swab, directly on the mildew
stain. Dab repeatedly with clear, cool water, and blot
dry.
Vehicle Appearance and Care
23.3