NOTE: The correct fluid level is established by
checking at the fill plug opening (manual and
automated) or the oil level dipstick (Procision).
1.
On manual and automated transmssions,
add
fluid until it is level with the lower edge of the fill
opening. See
. If the transmission has two
fill openings, add fluid to the level of both fill
openings. See
for approved transmission
lubricants. See
for lubricant capacities.
On Procision transmssions,
add fluid through the
transmission oil dipstick tube, until the level is
within the COLD range, as marked on the dip-
stick. See
for approved transmission lu-
bricants. See
for lubricant capacities.
2.
Check and adjust the fluid level using the appli-
cable Eaton Transmission fluid level checking
procedure in
3.
Clean the fill plug (if applicable), then install it in
the transmission. Tighten the plug as follows:
•
25 to 35 lbf·ft (34 to 48 N·m) for Eaton
Fuller transmissions with 3/4-inch pipe
threads.
•
60 to 75 lbf·ft (81 to 102 N·m) for Eaton
Fuller transmissions with 1-1/4-inch pipe
threads.
Eaton Fuller Transmission Lubricant Capacities
*
Transmission Model
†
Lubricant
Capacity:
qt (L)
5-Speed
FS–4205A/B, FS–5205A/B
6.25 (5.9)
FS–6305A/B
9.75 (9.2)
6-Speed
FS–5406A
9.75 (9.2)
FS–6406A, FSO–6406A
9.75 (9.2)
FO–6406A, FO-8406
10.5 (10.0)
FSO–8406A
9.75 (9.2)
7-Speed
T–14607A/B
18 (17.5)
TX–14607B
18 (17.5)
9-Speed
RT–6609A
6 (5.7)
RT–8709B
13.0 (12.3)
Eaton Fuller Transmission Lubricant Capacities
*
Transmission Model
†
Lubricant
Capacity:
qt (L)
RT–8608L
13.5 (12.7)
10-Speed
FR–9210B
11.75 (11)
FRO–14210C, FRO–15210C
11.75 (11)
RT–8908LL
14 (13.2)
RTO–10910B AS2
13 (12.3)
RTO–11908LL
14 (13.2)
11-Speed
RTO–11909ALL
14 (13.2)
13-Speed
RTLO–14913A
14 (13.2)
18-Speed
RTLO–14918B
14 (13.2)
RTLO–16918B
14 (13.2)
Procision 7-Speed Dual Clutch
EDCO-9N107A, EDCO-6F107A
12.7 (12)
*
Quantities listed are approximate. Fill the transmission until the lubricant
is level with the bottom of the fill hole, with the vehicle in normal operating
position.
†
For models not listed in this table see the Eaton Fuller website,
Table 6, Eaton Fuller Transmission Lubricant
Capacities
26–03 Allison and Eaton Fuller
Transmission Breather
Checking
Transmission housing breathers (if equipped) must
remain clear. A plugged breather could result in pres-
sure build-up, which could cause oil leakage.
If the breather is plugged, clean or replace it. See
. Check more often if the vehicle is operating
under very dusty conditions.
Transmission
26
Business Class M2 Maintenance Manual, March 2016
26/5
Property of American Airlines
