5.2
Push on the wedge stop rod with hand
pressure. It should move in 1/4 inch (6
mm) and spring back out on release.
If the free travel is not 1/4 inch (6 mm),
adjust the distance to 1/4 inch (6 mm) by
turning the wedge stop rod, on the right
side of the top plate, clockwise to reduce
the gap and counter-clockwise to in-
crease it.
ConMet Simplex®
1.
Disconnect the tractor from the trailer. For in-
structions, see
Chapter 10
of the
Business
Class® M2 Driver’s Manual
2.
Thoroughly steam-clean the fifth wheel.
3.
Check the fifth wheel plate for cracks. Check for
sharp edges on top; the chamfer should be 1/8
to 1/4 inch (3 to 6 mm).
4.
When the wheel is locked, the safety latch must
swing free and fall freely into position. See
5.
The lever bar and operating handle must be in
proper alignment. See
. Replace any bent
or misaligned lever bar or operating rod.
6.
Check all clinch pins for cracking or damage.
Replace any clinch pin that shows signs of dam-
age.
7.
Measure the top plate lift. See
7.1
Level the fifth wheel plate to a horizontal
position.
7.2
Measure the height from a stationary
mounting point, such as the frame rail to
the top of the fifth wheel plate.
f310353b
1
2
3
4
10/26/2010
1.
Lubricant Grooves
2.
Safety Latch
3.
Lock Control Handle
4.
Mount
Fig. 1, Simplex Series Fifth Wheel
04/11/2011
f310470
1
2
1.
Operating Handle
2.
Lever Bar
Fig. 2, Lever Bar and Operating Handle Alignment
f310475
04/11/2011
1
2
3
A
4
5
A. Extended Top Plate Lift Height
1.
Fifth Wheel Top Plate
2.
Fifth Wheel Frame Mount
3.
Frame Rail
4.
Lifting Point
5.
Static Top Plate Height
Fig. 3, Measuring Fifth Wheel Top Plate Lift
Frame and Frame Components
31
Business Class M2 Maintenance Manual, March 2016
31/2
Property of American Airlines