Daikin UATYP-AY1(B), Operating Manual

Page: 5 / 48

3
Lower slot
for opening LCD
casing
Connection behind
top case
LCD Remote
(Bottom case)
Connection
wires
LCD Remote
(Top case)
2 x Wooden
screw
Connection at
main board
GND
+5V
B
A
GND
+5V
B
A
2
Wooden screw 4.1 x 16 (2 pieces)
3
Instruction manual
4.2 Step-by-step Guide
i) First, open up the casing of the LCD remote controller into its top and bottom
case using a screwdriver. To do this, insert the screwdriver into the lower slot and
slide it in the outward direction.
ii) Fix the bottom case onto the wall with the 2 wooden screws provided. Then,
insert the 4 connecting wires (from the main board) through the slot on the lower
center of the case as shown below.
iii) Connect one end in each of the 4 wires to the terminal block behind the top case
as illustrated. The wire that goes into the “GND” terminal at the top case must be
connected at the other end to the “GND” terminal at the main board. The same
goes for the “+5V”, “B” and “A” connection.
iv) Fasten back the top and bottom case into place. Hook the two upper claws into
their respective slots and snap the lower part shut.
OM-SEQ-0107-Daikin_EN_NL 3/6/07, 9:43 AM 3