Daikin UATQ-C Series, Installation Manual

Page: 13 / 40

11
English
3
4 1 1 2 9 4
6 4 5
ID4 ID3 ID2 ID1
TRANSFORMER
DS4 DS3 DS2 DS1 ROOM
F2H
A1
T
A2 W V
S
U
R
N
OUT FAN 2 OUT FAN 1
OUT FAN 4
NEUTRAL
LIVE
4WV 2 IN F
AN
4WV 1
HEA
TER2
HEA
TER1
COMP
2 COMP
1
L1 L2 L3 N
RESET
95
98
96
2 6
R S T
U V W
F13.15A
7A 250V
N N N N
C1
!
WARNING
Before working in this unit, isolate it from the power supply.
Electrical wiring to this unit and the remote controller shall be installed in accordance with the appropriate
requirement of the local wiring code. •
•
Observe the notes mentioned below when wiring to the terminal block.
Precautions to be taken for power supply wiring.
(Use a round crimp-style terminal for connection to the terminal block.
In case it cannot be used due to unavoidable reasons, be sure to observe
the following instruction.)
!
CAUTION
When connecting the connection wires to the terminal block using a single core wire, be sure to perform curling.
Problems with the work may cause heat and fires. •
Pull the wire and make sure that it does not disconnect. Then fix the wire in place with a wire stop. •
Stripping wire at terminal block
Good Wrong
Strip wire end
to this point.
Excessive strip length
may cause electrical
shock or leakage.
Round crimp-style
terminal
Stranded wire
No. Item Description
1 Contactor
2 Capacitor
3 Phase Protector
4 Terminal Block
5 Relay
6 Fuse
7 Transformer
8 Timer
9
Control Module
(4) Arrangement of terminal blocks and components for controller are shown as below:
(a) Sequential Control
Model : UATQ60/90C
!
WARNING
Transmission wire must be routed at least 50mm away from the power cable.
Transmission wire should be a shielded wire. •
•
1-IM-5RTC-0315(2)-DAIKIN-EN.indd11 11 1-IM-5RTC-0315(2)-DAIKIN-EN.indd11 11 1/14/16 1:55:59 PM 1/14/16 1:55:59 PM