Daikin RYYQ8U7Y1B, Installer And User Manual

Page: 104 / 176

17 | Piping installation
Installer and user reference guide
104
RYYQ+RYMQ+RXYQ
VRV IV+ heat pump
4P546228-1C – 2021.11
Charging refrigerant
5 After pre-charging, connect valve A to the refrigerant charge port and charge
the remaining additional refrigerant through this port. Open all outdoor unit
stop valves. At this point, valve A must remain closed!
p< p>
R410A
a c
d
b
A
INFORMATION
For a multi outdoor unit system, it is not required to connect all charge ports to a
refrigerant tank.
The refrigerant will be charged with ±22 kg in 1 hour time at an outdoor temperature
of 30°C DB or with ±6 kg at an outdoor temperature of 0°C DB.
If you need to speed up in case of a multiple outdoor system, connect the refrigerant
tanks to each outdoor unit.
NOTICE
▪
The refrigerant charging port is connected to the piping inside the unit. The unit's
internal piping is already factory charged with refrigerant, so be careful when
connecting the charge hose.
▪
After adding the refrigerant, do not forget to close the lid of the refrigerant
charging port. The tightening torque for the lid is 11.5 to 13.9 N•m.
▪
In order to ensure uniform refrigerant distribution, it may take the compressor
±10 minutes to start up after the unit has started operation. This is not a
malfunction.
6 Proceed with one of the following:
6a "17.4.6 Step 6a: To automatically charge refrigerant" [
4
104]
6b "17.4.7 Step 6b: To manually charge refrigerant" [
4
106]
INFORMATION
After charging refrigerant:
▪
Record the additional refrigerant amount on the refrigerant label provided with
the unit and attach it to the backside of the front panel.
▪
Input the additional refrigerant amount into the system via setting [2‑14].
▪
Perform the test procedure described in "20 Commissioning" [ 4 145].
17.4.6 Step 6a: To automatically charge refrigerant
INFORMATION
The automatic refrigerant charging has limits as described below. Out of these limits,
the system cannot operate the automatic refrigerant charging:
▪
Outdoor temperature: 0~43°C DB.
▪
Indoor temperature: 10~32°C DB.
▪
Total indoor unit capacity: ≥80%.