Daikin RoofPak RPS Series, Installation And Maintenance Manual

Page: 9 / 130

Introduction
www.DaikinApplied.com 9 IM 926-3 • ROOFPAK APPLIED SYSTEMS
Control Locations
Figure 9 (RPS Units) and Figure 10 (RDT Units) show
the locations of the various control components mounted
throughout the units. See Control Panel on page 10 for the
locations of control components mounted in control panels.
Additional information is included in Table 3 on page 15
and the wiring diagram legend, which is included in Wiring
Diagrams on page 63 . Components mounted in the blow-
through section are located in the same position within the
draw-through section.
Figure 9: Control Locations—RPS Units
Figure 10: Control Locations—RDT Units
R eturn air
economizer
F ilter
se ction
Supply
fan
Heat
DX
se ction
Discharge
plenum
se ction
C ondensor
se ction
R AT
LT11
(optional)
S11,
REC11
OAE
AC T3
P C 5
S 10, R E C 10
LT10
HL22
E F T
S D1
VM1
DAT
ACT5 (optional)
S V1
S V2
(optional)
(optional)
(optional)
(optional)
(optional)
se ction
se ction
FS1
(optional)
C19
OAT
AC T6 (optional)
RAE (optional)
SD2
(optional)
PC7
C11, 12
(optional)
SC11, 12
(optional)
Economizer
Filter
Heat
section
Supply fan
discharge
plenum
section
Condenser
C19, 20
RAT
LT11 (optional)
S11, REC11
SD2
RAE
ACT3
PC5
OAE
VM1
LT10 (optional)
DAT
OAT
SV1, 2
SC11, 21
(optional)
C11, 21
(optional)
(optional)
DX
section
section
section
return air
(optional)
(optional)
(optional)
(optional)
C9
FS1
(optional)
S10, REC10 (optional)
SD1 (optional)
ACT6