20
English
Read First
2
If router does not have built-in WPS
Connect air purifier to network
Follow the steps below even if you are choosing to not use WPS.
1
Press
to activate the wireless LAN connection adapter.
2
Launch the app and follow the guidance to connect the air purifier and router.
• SSID and KEY are required for connection.
(A sticker with the SSID and KEY can be found in the location shown in the illustration on the
right.)
Location of SSID and KEY
For detailed specifications, installation instructions, setting methods, FAQ, declaration of conformity and the latest version of this
manual, visit app.daikineurope.com.
Communication lamp status
Lights up or blinks according to the wireless LAN communication status, as shown below.
Lit up
Green
Wireless LAN connection adapter is connecting to router
Orange
• Wireless LAN connection adapter and router connection not set
• Wireless LAN connection adapter is connecting to router (immediately after turning
communication “ON”)
Red
Wireless LAN connection adapter cannot connect to the Internet
Unlit
Wireless LAN connection adapter function is “OFF”
If the unit (air purifier) can’t be found with the app
• Perform connection settings again.
•
Move the router closer to the air purifier.
If you want to turn the wireless LAN connection adapter function
“OFF”
Press
.
If you want to turn the adapter function “ON”, press
again.
if necessary
If you want to reset the wireless LAN connection adapter to factory default settings
• If you want to redo the settings, etc., the wireless LAN connection adapter can be reset to the factory default settings from
the time of purchase.
If you reset to factory default settings, network settings will be erased, as well as historical data such as the number of
sensor responses.
• If disposing of the unit or transferring it to a new user, reset it to factory default settings in order to erase the internal data.
1 Press
to turn on the communication lamp.
2 Press and hold
and
at the same time for about 5 seconds while the unit is stopped.
• A short beep sounds, and the communication lamp (orange) and the AUTO operation lamp (white) blink for about
20 seconds.
• When reset to factory default settings is completed, a long beep sounds and all lamps turn off.
• If, after step 2 , the communication lamp lights up and only the AUTO operation lamp turns off, repeat steps 1 and 2 .
01_EN_3P693800-1D.indd 20
2023/06/26 13:41:28
