Daikin homecontrols EKRUFHT61V3, Installation And Operation Manual

Page: 14 / 28

14
Start-up
5.2 DIN rail mounting
To mount the DHC Floor Heating Controller to a DIN rail, proceed as follows:
1. Place the DHC Floor Heating Controller onto the DIN rail
(see figure 4)
.
2. Press the spring latches (E) upwards
(see figure 4)
.
Make sure that the spring latches are completely latched and that
the accessory is seated solidly on the rail.
6 Start-up
6.1 Installation instructions
Read this entire section before starting installation.
Only to be installed by persons with the relevant electro-
technical knowledge and experience!*
Incorrect installation can put your own life at risk and the lives of other
users of the electrical system. Incorrect installation also means that you
are running the risk of serious damage to property, e.g. because of a fire.
You may be personally liable in the event of injuries or damage to property.
Contact an electrical installer!
*Specialist knowledge required for installation:
The following specialist knowledge is particularly important during
installation:
• The “5 safety rules” to be used: Disconnect from mains;
Safeguard from switching on again; Check that system is
de-energised; Earth and short circuit; Cover or cordon off