Daikin homecontrols EKRRVATU1BA, Installation And Operation Manual

Page: 20 / 36

20
Start-up Start-up
5.2.3 Support ring
The valves from different manufacturers may have toler -
ance fluctuations that make the DHC Radiator Thermostat
more loosely seated on the valve. In this case, place the
provided support ring (R) into the flange before mounting
the device (
see figure 5
).
5.3 Adaption run
Once the batteries have been inserted, the motor
reserves. “ ” and the activity symbol ( )
are displayed.
After mounting the DHC Radiator Thermostat, an adaption
run ( ) has to be performed to adapt the acces-
soryto the valve. To do this, proceed as follows:
1. As soon as “ ” is displayed, press the
control wheel/boost button (A) .
» “ ” and ( ) are displayed during the
adaption run ( see figure 11 ). During this time, no
other operation is possible.
» After the adaption run has been successful, the
display returns back to normal.
If the adaption run has been initiated prior to
mounting or if an error message (F1, F2, F3) is
displayed, press the control wheel/boost button
(A) and the motor reverses to the “ ”
position.
Danfoss RAVL
The Danfoss valve bodies have elongated notches (1)
around their circumference, which also ensure that the
adapter is properly seated when it snaps on.
During installation, make sure that the pins inside
the adapter (2) are lined up with the notches (1) on
the valve. Make sure that a suitable adapter for
the valve is properly clipped on.
The adapter RAVL does not have to be fixed with screws.
2
1
RAVL