8
To set the batteries
Slide the front cover to take it off.
1.
Set 2 dry batteries AAA.LR03 (alkaline).
2.
Set the front cover as before.
3.
To
fi
x the remote controller holder on the wall
Choose a place from where the signals reach
1.
the unit.
Fix the holder to a wall, a pillar, etc. with the
2.
screws supplied with the holder.
Place the remote controller in the remote
3.
controller holder.
Turn the breaker ON
Turning ON the breaker closes the
fl
ap. (This is a normal procedure.)
•
2
3
1
Position and
correctly!
+
–
Remote controller
holder
Set.
Pull.
Preparation before Operation
ATTENTION
About batteries
When replacing the batteries, use batteries of the same type, and replace the 2 old batteries together.
•
When the system is not used for a long time, take the batteries out.
•
The batteries will last for approximately 1 year. If the remote controller display begins to fade and the degradation of reception performance
•
occurs within a year, however, replace both 2 batteries with new, size AAA.LR03 (alkaline).
The attached batteries are provided for the initial use of the system.
•
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
About remote controller
Never expose the remote controller to direct sunlight.
•
Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
•
Signal communication may be disabled if an electronic-starter-type
fl
uorescent lamp (such as inverter-type lamps) is in the room. Consult the
•
shop if that is the case.
If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the service shop.
•
01_EN_3P191290-3K.indd 8
01_EN_3P191290-3K.indd 8
5/21/2009 7:50:19 PM
5/21/2009 7:50:19 PM
