Daikin FTXS80KVMA, Operation Manual

Page: 14 / 34

13
■
To start 3-D airflow
1. 3. Press the “SWING button ” and the “SWING button ”:
the “ ” and “ ” display will light up and the flap and louvers will
move in turn.
■
To cancel 3-D airflow
2. 4. Press either the “SWING button ” or the “SWING button ”.
■
COMFORT AIRFLOW operation
• Check COMFORT AIRFLOW operation in the section of “COMFORT AIRFLOW Operation” and
“INTELLIGENT EYE Operation”. (page 14, 15.)
Notes on flaps and louvers angles
• When “ SWING button ” is selected, the flaps
swinging range depends on the operation mode.
(See the figure.)
Three-Dimensional (3-D) airflow
• Using three-dimensional airflow circulates cold
air, which tends to collected at the bottom of the
room, and hot air, which tends to collect near the
ceiling, throughout the room, preventing areas of
cold and hot developing.
■
ATTENTION
• Always use a remote controller to adjust the
angles of the flaps and louvers. If you attempt to
move the flaps and louvers forcibly with hand
when they are swinging, the mechanism may be
broken.
• Always use a remote controller to adjust the
louvers angles. In side the air outlet, a fan is
rotating at a high speed.
COOL and DRY mode
FAN mode
Lower limit (100˚)
Upper limit (45˚)
Stop
operation
COMFORT
AIRFLOW (40˚)
Stop
operation
Upper
limit (45˚)
Lower limit (80˚)
HEAT mode
Upper limit (60˚)
Stop
operation
Lower limit (100˚)
COMFORT
AIRFLOW (105˚)
01_EN_3P266961-1.fm Page 13 Tuesday, June 8, 2010 2:36 PM