Daikin FTXG25CVMAW, Operation Manual

Page: 22 / 30

21
1. Open the top front panel.
• Open the top front panel by placing a finger on the
panel tab on either side of the top front panel and
then secure it using the supporting plate on the right.
2. Pull out the air filters.
• Push a little upwards the tab at the center of
each air filter, then pull it down.
3. Take off the Titanium Apatite
Photocatalytic Air-Purifying Filter.
• Hold the recessed parts of the frame and
unhook the four claws.
4. Clean or replace each filter.
See figure.
5. Set the air filter and the Titanium Apatite
Photocatalytic Air-Purifying Filter as they
were and close the front grille.
• Be sure to insert the two tabs below.
• Return the supporting plate to its previous position.
• Press either side of the top front panel.
■
Air Filter
1. Wash the air filters with water or clean them with
vacuum cleaner.
• If the dust does not come off easily, wash them with neutral detergent
thinned with lukewarm water, then dry them up in the shade.
• It is recommended to clean the air filters every two weeks.
■
Titanium Apatite Photocatalytic
Air-Purifying Filter. (gray)
The Titanium Apatite Photocatalytic Air-Purifying Filter can be renewed
by washing it with water once every 6 months. We recommend replacing it once every 3 years.
[ Maintenance ]
1. Remove dust with a vacuum cleaner and wash lightly with water.
2. If it is very dirty, soak it for 10 to 15 minutes in water mixed with a neutral cleaning agent.
3. Do not remove filter from frame when washing with water.
4. After washing, shake off remaining water and dry in the shade.
5. Since the material is made out of paper, do not wring out the filter when removing water from it.
[ Replacement]
1. Remove the tabs on the filter frame and replace with a new filter.
• Dispose of the old filter as flammable waste.
Filters
Supporting plate
Air filter
Titanium Apatite
Photocatalytic
Air-Purifying Filter
Filter frame
Tab
Push
Tab
01_EN_3P119312-2C.fm Page 21 Thursday, October 13, 2005 2:30 PM