![background image](http://html1.mh-extra.com/html/daikin/ftxf50a2v1b/ftxf50a2v1b_operation-manual_2459429009.webp)
7 Maintenance and service
Operation manual
9
FTXF50~7 FTXF50~71A2V1B
Daikin room air conditioner
3P511999-6J – 2021.07
WARNING
The refrigerant inside the unit is mildly flammable, but
normally does NOT leak. If the refrigerant leaks in the
room and comes in contact with fire from a burner, a
heater, or a cooker, this may result in fire, or the formation
of a harmful gas.
Turn off any combustible heating devices, ventilate the
room, and contact the dealer where you purchased the
unit.
Do NOT use the unit until a service person confirms that
the part from which the refrigerant leaked has been
repaired.
WARNING
▪ Do NOT pierce or burn refrigerant cycle parts.
▪ Do NOT use cleaning materials or means to accelerate
the defrosting process other than those recommended
by the manufacturer.
▪ Be aware that the refrigerant inside the system is
odourless.
WARNING
The appliance shall be stored so as to prevent mechanical
damage and in a well-ventilated room without continuously
operating ignition sources (e.g. open flames, an operating
gas appliance, or an operating electric heater). The room
size shall be as specified in the General safety precaution.
NOTICE
Maintenance MUST be done by an authorised installer or
service agent.
We recommend performing maintenance at least once a
year. However, applicable legislation might require shorter
maintenance intervals.
DANGER: RISK OF ELECTROCUTION
To clean the air conditioner or air filter, be sure to stop
operation and turn all power supplies OFF. Otherwise, an
electrical shock and injury may result.
WARNING
To prevent electrical shocks or fire:
▪ Do NOT rinse the unit.
▪ Do NOT operate the unit with wet hands.
▪ Do NOT place any objects containing water on the unit.
CAUTION
After a long use, check the unit stand and fitting for
damage. If damaged, the unit may fall and result in injury.
CAUTION
Do NOT touch the heat exchanger fins. These fins are
sharp and could result in cutting injuries.
WARNING
Be careful with ladders when working in high places.
Following symbols may occur on the indoor unit:
Symbol
Explanation
Measure the voltage at the terminals of main circuit
capacitors or electrical components before servicing.
7.2
To clean the indoor unit and user
interface
WARNING
Improper detergents or cleaning procedure may cause
damage on plastic components or water leakage.
Splashed detergent on electric components, such as
motors, may cause failure, smoke or ignition.
NOTICE
▪ Do NOT use gasoline, benzene, thinner, polishing
powder or liquid insecticide.
Possible consequence:
Discoloration and deformation.
▪ Do NOT use water or air of 40°C or higher.
Possible
consequence:
Discoloration and deformation.
▪ Do NOT use polishing compounds.
▪ Do
NOT
use
a
scrubbing
brush.
Possible
consequence:
The surface finishing peels off.
▪ As an end user, you may NEVER clean inside parts of
the unit by yourself; this work must be performed by a
qualified service person. Contact your dealer.
DANGER: RISK OF ELECTROCUTION
Before cleaning, be sure to stop the operation, turn the
breaker OFF or pull out the supply cord. Otherwise, an
electrical shock and injury may result.
1
Clean with a soft cloth. If it is difficult to remove stains, use
water or a neutral detergent.
7.3
To clean the front panel
1
Clean the front panel with a soft cloth. If it is difficult to remove
stains, use water or a neutral detergent.
7.4
To open the front panel
1
Hold the front panel by the panel tabs on both sides and open
it.
7.5
To clean the air filters
1
Push the tab at the centre of each air filter, then pull it down.
2
Pull out the air filters.