Basic Operation
14
English
You can adjust the airflow direction to increase your comfort.
CAUTION
•
Always use a remote controller to adjust the angles of the flaps and louvers.
− If you attempt to move the flaps and louvers forcibly by hand when they are swinging, the mechanism may
be damaged.
− Inside the air outlet, a fan is rotating at a high speed.
To start auto swing
Up and down airflow direction
Press
.
• “
” is displayed on the LCD.
•
The flaps (horizontal blades) will begin to swing.
Right and left airflow direction
Press
.
• “
” is displayed on the LCD.
•
The louvers (vertical blades) will begin to swing.
The 3-D airflow direction
Press
and
.
• “
” and “
” are displayed on the LCD.
•
The flaps and louvers move in turn.
•
To cancel 3-D airflow, press either
or
again.
The flaps or louvers will stop moving.
To set the flaps or louvers at the desired position
•
This function is effective while the flaps or louvers are in auto swing mode.
Press
and
when the flaps or louvers
reach the desired position.
•
In the 3-D airflow, the flaps and louvers move in turn.
• “
” or “
” disappears from the LCD.
NOTE
Notes on airflow direction setting
•
The movable range of the flaps varies according to the operation mode.
•
If the airflow rate becomes weak during operation, the flaps and louvers will stop.
When up and down airflow direction is set, the flaps will stop in an upward position.
•
When the airflow rate setting is low, or when 3-D airflow direction is set, the room temperature may
not reach the set temperature (for example, if the air conditioner is blowing air toward the wall).
In that case, change the airflow direction or the airflow rate.
Note on 3-D airflow
•
Using 3-D airflow circulates cold air, which tends to collected at the bottom of the room,
and hot air, which tends to collect near the ceiling, throughout the room, preventing areas
of cold and hot developing.
COOL / DRY
FAN
HEAT
Movable range of the flaps
Adjusting the Airflow Direction
01_EN_3P686868-1.indd 14
2022/06/01 15:31:27
