SiENBE12-713
Printed Circuit Board Connector Wiring Diagram
Printed Circuit Board Connector Wiring Diagram
43
1.1.3 FTK(X)S50~71F
Connectors
PCB(1) (Control PCB)
PCB(2) (Signal Receiver PCB)
PCB(3) (Buzzer PCB)
PCB(4) (Display PCB)
PCB(5) (INTELLIGENT EYE sensor PCB)
Note:
Other designations
PCB(1) (Control PCB)
PCB(2) (Signal Receiver PCB)
PCB(3) (Buzzer PCB)
PCB(4) (Display PCB)
1) S1
Connector for DC fan motor
2) S6
Connector for swing motor (horizontal blades)
3) S8
Connector for swing motor (vertical blades)
4) S21
Connector for centralized control (HA)
5) S26
Connector for buzzer PCB
6) S28
Connector for signal receiver PCB
7) S32
Connector for heat exchanger thermistor
8) S35
Connector for Intelligent Eye sensor PCB
1) S29
Connector for control PCB
1) S27
Connector for control PCB
2) S38
Connector for display PCB
1) S37
Connector for buzzer PCB
1) S36
Connector for control PCB
1) V1
Varistor
2) JA
Address setting jumper
JB
Fan speed setting when compressor is OFF on thermostat
JC
Power failure recovery function
∗
Refer to page 321 for detail.
3) LED A
LED A for service monitor (green)
4) FU1
Fuse (3.15A)
1) SW1 (S1W)
Forced operation ON/OFF switch
1) RTH1 (R1T)
Room temperature thermistor
4) LED1
LED for operation (green)
5) LED2
LED for timer (yellow)
6) LED3
LED for HOME LEAVE operation (red)
Summary of Contents for FTKS20D3VMW
