![background image](http://html1.mh-extra.com/html/daikin/ftkf25xvmv/ftkf25xvmv_operation-manual_4222117010.webp)
READ BEFORE OPERATION
OPERATION
Preparation Before Operation
To set the batteries
1
Slide the back cover to take it off.
Position and
correctly!
Set two dry batteries
AAA.LR03 (alkaline).
2
3
Set the back cover as before.
To operate the remote controller
• To use the remote controller, aim the transmitter at the indoor
unit. If there is anything blocking signals between the unit and
the remote controller, such as a curtain, the unit will not operate.
• Do not drop the remote controller. Do not get it wet.
• The maximum distance for communication is about 7m.
To fix the remote controller
holder on the wall
1. Choose a place from where the signals reach the unit.
2. Fix the holder to a wall, a pillar, etc. with the screws
supplied with the holder.
3. Place the remote controller in the remote controller holder.
Turn the breaker on
•
After the power is turned on, the flap of the indoor unit opens and
close once to set the reference position.
Receiver
7 m
Remote
controller
holder
Screws
Remote controller
ATTENTION
About batteries
• When replacing the batteries, use batteries of the same type, and replace the 2 old batteries together.
• When the system is not used for a long time, take the batteries out.
• The batteries will last for approximately one year. If the remote controller display begins to fade
and the degradation of reception performance occurs within a year, however, replace both two
batteries with new size AAA.LR03 (alkaline) batteries.
• The attached batteries are provided for the initial use of the system. The usable period of the
batteries may be short depending on the manufactured date of the air conditioner.
• When battery power has run out, “
” will begin blinking as an alert that the batteries need
replacing. In some cases, when battery consumption is accelerated owing usage conditions,
signal reception may decline before “
” begins blinking.
About remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
•
Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as
inverter-type lamps) is in the room. Consult the shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance to
somewhere else, or consult the shop.
8
01_EN_3P658678-11W.indd 8
03-Feb-23 4:44:48 PM