Daikin D-Series, Service Manual

Page: 318 / 479

Si18-525B Instruction
Operation Manual 305
For programming TEMPERATURE, FAN SPEED
and AIR FLOW DIRECTION, follow the procedure
shown below.
TEMPERATURE SETTING
Press TEMPERATURE SETTING button and
program the setting temperature.
Each time this button is pressed, setting
temperature rises 1˚C.
Each time this button is pressed, setting
temperature lowers 1˚C.
• The setting is impossible for fan operation.
NOTE
• The setting temperature range of the remote con-
troller is 16˚C to 32˚C.
FAN SPEED CONTROL
Press FAN SPEED CONTROL button.
High or Low fan speed can be selected.
The micro computer may sometimes control the fan
speed in order to protect the unit.
AIR FLOW DIRECTION ADJUST
• There are 2 ways of adjusting the air discharge
angle.
1. A. Up and down adjustment
2. B. Left and right direction
Fig. 1
A. UP AND DOWN DIRECTION
• The movable limit of the flap is changeable. Con-
tact your Daikin dealer for details.
ADJUSTMENT
Press the AIR FLOW DIRECTION ADJUST
button to select the air direction as follow-
ing.
The AIR FLOW FLAP display
swings as shown the left and
the air flow direction continu-
ously varies. (Automatic swing
setting)
Press AIR FLOW DIRECTION
ADJUST button to select the air
direction of your choice.
The AIR FLOW FLAP display
stops swinging and the air flow
direction is fixed (Fixed air flow
direction setting).
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, micro computer con-
trols the air flow direction so it may be different from
the display.
Operation mode includes automatic operation.
B. LEFT AND RIGHT DIRECTION
• Adjusting air flow direction in the left and right
direction. (Refer to Fig. 1)
NOTE
• Only make adjustments after you have stopped
the air flow direction swing in a position where
adjustments are possible. Your hand may get
caught if you attempt to make adjustments while
the unit is swinging.
Operation
mode
Cooling Heating
Operation
condition
• When room
temperature is
lower than the
set temperature
• When room
temperature is
higher than the set
temperature
• At defrost opera-
tion
• When operating continuously at
downward air flow direction