17
2. BEFORE INSTALLATION
2-1 ACCESSORIES
Check if the following accessories are
attached to this kit.
Name
Receiver
(1) Receiver
assembly
(2) Transmission
printed circuit
board
Quantity
1 set
1 pc.
Shape
Name
(3) Wire harness
- long
(4) Wire harness
- short
Quantity
1 pc.
1 pc.
Shape
Name
Wireless remote
controller
Screw for
installing remote
controller holder
Quantity
1 pc.
2 pcs.
Shape
M3.5×16
Name
Remote controller
holder
(5) Unit No. label
Quantity
1 pc.
1 pc.
Shape
1
1
1
2
2
2
3
3
3
Name
(6) Control panel
(with label)
Dry cell battery
AAA. LR03 (alkaline)
Quantity
1 pc.
2 pcs.
Shape
Name
(7) Clamp
Sealing
material (8)
Operation &
Installation
manual
Quantity
1 pc.
1 pc.
1 pc.
Shape
2-2 OPTIONAL ACCESSORIES
For this Wireless Receiver Kit, the wireless
remote controller is separately required.
Refer to the catalog for the applicable model.
(Refer to also the installation manual attached to
the wireless remote controller for how to install.)
2-3 NOTE TO THE INSTALLER
•
Have the customer actually operate the system
while looking at the operation manual.
Instruct the customer how to operate the system.
3. REMOTE CONTROLLER
INSTALLATION
<Installing wireless remote controller>
•
Do not throw the remote controller or impose
large shocks. Also, do not store where it may
be exposed to moisture or direct sunlight.
•
When operating, point the transmitting part of the
remote controller in the direction of the receiver.
(Refer to the operation manual attached to this
kit.)
•
The maximum transmitting distance is 7 m.
This depends on the installation condition of
the indoor unit.
•
The signal cannot be transmitted if something
such as curtains blocks the receiver and the
remote controller.
•
Mounting the remote controller holder on a
wall
1. Fix the remote controller holder with the
screws.
2. Slide the wireless remote controller into the
remote controller holder from the top.
2
1
Fig. 1
Screw
Wireless remote
controller
Remote
controller
holder
01_EN_4P457494-6L.indd 17
13/03/2019 11:07:48