Installation
www.DaikinApplied.com 29
IM 1240-4 • INTELLIGENT EQUIPMENT
Antenna Installation
NOTE:
Only one of the two included antennas will be
installed and connected to the M2M Gateway.
DANGER
Electric shock hazard . Can cause personal injury or
equipment damage .
Prior to installing Intelligent Equipment hardware, power must be removed
from the unit. This means removing power at the breaker panel serving
the unit, and following proper lockout/tagout procedures at said breaker
panel for the duration of the install. Power should not be reapplied until all
electrical interconnections have been made and verified.
This equipment must be properly grounded. Connections and service to the
MicroTech II WMC Water Cooled chiller, MicroTech III Air Cooled Chiller,
MicroTech III Commercial Packaged Rooftop Unit Controller, Commercial
Packaged Rooftop, Applied Packaged Rooftop, or Commercial Outdoor
Air Handling Unit, Machine-to-Machine Gateway and Energy Management
Module must be performed only by personnel knowledgeable in the
operation of the equipment being controlled.
CAUTION
Static sensitive components . Can cause equipment
damage .
Discharge any static electrical charge by touching the bare metal inside the
control panel before performing any service work. Never unplug cables,
circuit board terminal blocks, or power plugs while power is applied to the
panel.
CAUTION
Sharp edges on sheet metal and fasteners can cause personal injury.
This equipment must be installed, operated, and serviced only by an
experienced installation company and fully trained personnel.
Mounting
The antenna provided with the Intelligent Equipment solution
(
) is omni-directional, and has a swiveling base.
The antenna to be oriented should avoid interference from
structures or other antennas. For initial installation, it is
recommended to install the antenna on top of the rooftop
unit, with enough clearance from the edge to avoid accidental
contact or damage. The antenna is held in place by its
magnetic base. You will find more information about aiming
antennas in the sections,
Wi-Fi Configuration on page 31
and
of this document.
Figure 68: Wireless Antenna on Magnetic Mounting Base
Summary of Contents for AGZ-D
Page 45: ......
