Daikin 2MXM40M4V1B, Installer'S Reference Manual

Page: 56 / 76

11 | Configuration
Installer reference guide
56
2(A)MXM40+50 + 2(A)MXF40+50
R32 Split series
4P600463-2C – 2020.08
11 Configuration
In this chapter
11.1 About ECONO mode prohibition setting................................................................................................................................ 56
11.1.1 To turn on ECONO mode prohibition setting ........................................................................................................ 56
11.2 About night quiet mode ......................................................................................................................................................... 57
11.2.1 To turn on the night quiet mode ........................................................................................................................... 57
11.3 About heat mode lock ............................................................................................................................................................ 57
11.3.1 To turn on heat mode lock..................................................................................................................................... 57
11.4 About standby electricity saving function.............................................................................................................................. 58
11.4.1 To turn on standby electricity saving function ...................................................................................................... 58
11.1 About ECONO mode prohibition setting
This setting disables the input control signal from the user interface. Use this
setting when you wish to block reception of input controls (cooling/heating) from
indoor unit user interfaces.
11.1.1 To turn on ECONO mode prohibition setting
Prerequisite: The main power supply MUST be turned off.
1 Remove the top plate of the outdoor unit (2 screws on sides)
2 Remove the electric box cover by sliding it. Be careful not to bend the electric
box hook.
3 Cut the jumper (J23).
a
c d e
b
J26 J24
J23
J6 J22 J8
a Top plate
b Electric box cover
c Electric box
d PCB
e PCB jumpers