Daihen OTC ARXIS pulse P403L, Owner'S Manual

Page: 59 / 188

C
HECK AND
S
ETTING OF
W
ELDING
C
ONDITION
W
ELDING
O
PERATION
C
HAPTER
5
57
Chapter 5 W
elding Operation
5.5 Check and Setting of Welding Condition
This section explains how to check the welding condition as well as how to prevent erroneous operation on the operation
panel (Erroneous operation prevention function).
5.5.1 Reading welding condition
Before starting the welding operation, it is necessary to set the welding JOB (such as welding current/voltage, type of
shield gas, and wire type/wire diameter). (
6.4
-
Preparing Welding JOB)
When the welding JOB are registered to memory, it can be read out. ( 6.5
-
Memory Function of Welding JOB)
When the condition is read, confirm that the welding JOB are correct.
5.5.2 Preventing erroneous operation on operation panel
This section explains how to prevent erroneous operation on the operation panel.
To prevent accidental change of the welding JOB, the erroneous operation prevention function is equipped for the
operations other than KEY LOCK DEACTIVATION key. In using the analog remote control, however, the adjustment of
current/voltage by the analog remote control is available.
5.5.2.1 Activating erroneous operation prevention function
1.
Menu > Key lock > ON

The HOME screen will be locked and panel operation other than KEY LOCK DEACTIVATION key will be
disabled.
T I P S
•
Turning the power switch OFF does not deactivate the erroneous operation prevention
function.
• Initializing the welding condition and the internal function deactivates the erroneous
operation prevention function.
(
7.5
-
Initializing Welding JOB and Internal Functions)
5.5.2.2 Deactivating erroneous operation prevention function
1.
Continue to press the key mark for 3 seconds to release the lock.

When a password has not been set, the lock is released and the screen returns to the HOME screen.