Daihen OTC ARXIS pulse P403L, Owner'S Manual

Page: 120 / 188

S
ETTING
I
NTERNAL
F
UNCTIONS
W
ELDING
C
ONDITION
C
HAPTER
6
118
– Internal function F48 (Adjusting current with torch switch) is set to "ON" (enabled); or
– Internal function F51 (Special crater repeat) is set to "ON" (enabled); or
– Either of the internal functions F29 to F32 (External input terminal setting) is set to either "4" (Start) or
"5" (Loading welding condition).
6.7.2.32 F45/F46/F47: Special 2T (effective/initial standard time setting/crater standard time
setting)
Incorporates start condition and crater condition in the "2T" sequence.
• Setting the internal function F45 to [ON] enables to carry out the start welding/crater treatment set by F46/F47 even
in the welding of "2T" condition.
• When this function is enabled, "special crater" is displayed in the HOME screen, enabling the internal functions F46
and F47.
• To the internal function F46, set the time for initial welding in the range of 0.0 to 10.0 seconds. Set the value in the
range of 0.0 to 10.0 seconds.
• To the internal function F47, set the crater treatment time in the range of 0.0 to 10.0 seconds. Set the value in the range
of 0.0 to 10.0 seconds.
T I P S
•
When the internal function F45 is set to [ON], automatically the setting of "special crater" is
selected, disabling other welding modes. (The 2T/4T menu does not work.)
• Welding process at crater treatment is the same as that of main welding.
• In the following cases, this function cannot be used:
– Internal function F11 (Fine adjustment of welding JOB memory) is set to "1" to "30" (enabled);
– Internal function F44 (Reading welding JOB with remote control) is set to "ON" (enabled);
– Internal function F48 (Adjusting current with torch switch) is set to "ON" (enabled); or
– Internal function F51 (Special crater repeat) is set to "ON" (enabled); or
– Either of the internal function F29 to F32 (External input terminal setting) is set to "5" (Loading welding
condition).
㻌 㻌 㻌 㻌
ON
OFF
Torch switch
Gas flow
Output voltage
Wire feeding speed
Welding current
Pre-flow
Post-flow
Anti-stick time
No-load voltage
Slow-down speed
Crater-fil
㼘
Main welding
Start current
Crater-fill current
Welding current
Start condition
Set the time by F46
(0.0 to 10.0 seconds)
Set the time by F47
(0.0 to 10.0 seconds)