DAIHAN-Sci.com or
ALL
for
LAB.com
Shopping Mall
Digital Jar Tester
11 /40
Installation
6
1. After receiving the unit and putting it on the specified place of use, remove the wrapping.
2. Check the unit on eventual transport damages. In case there are some transport damages
found please inform the forwarder and your contractor. If there is no damage please go to
point 3.
3. Let the unit stand for a few minutes so that the all the internal parts and components of the
unit can be stabilized.
4. Connect the mains cord to the socket.
WARNING
Place the device on a level, horizontal surface to support the capacity of the device
without vibration. If there is vibration, install the device on a support material with
enough space. Small place may cause the device to drop.
Do not install at a dangerous place.
Do not operate the device where there are flammables. It could be caused serious
accidents like explosion or fire.
Do not operate the device outside.
Avoid areas where the sun shines or rain directly on the device. It is very dangerous
as cause over-heat or a short circuit.
Do not install the device where it can get damp or dust.
It may be caused overheating, a short circuit or a fire by damp or dust inside of the
device.
Do not use this device when temperature fall below 5
°
C and rise above 40
°
C.
