43
3.8.1 Remote Control Calibration
If it isn’t turned to maximum value end, it may not respond to operation, operation is not smooth,
and the aircraft may even explode after calibration.
Select “Settings > Remote Control Settings> Joystick Calibration”.
The system displays “Joystick Calibration” interface, as shown in Figure 3-26.
Figure 3-26
Move both the left and right joysticks back to the middle.
Click “Start Calibration”.
Turn two joysticks and turn to the maximum value end of each direction for several
times.
Slide the rolling wheels on both sides, slide to the maximum value end of two directions
for several times.
Click “Complete Calibration” after turning the rolling wheels and joysticks.
After calibration, view “3.6.5.1 Dashboard“, and turn corresponding buttons to confirm if
calibration is successful. After successful calibration, each parameter is about 1514.
Turning the endpoint, maximum value is 19XX while minimum value is 10XX.
The remote control can be normally used about 30s after calibration.
3.8.2 Accelerometer Calibration
Select “Settings > General > Other > Accelerometer Calibration” to enter “Accelerometer
Calibration” interface, as shown in Figure 3-27.
Summary of Contents for NAVIGATOR X1100
