10
Draw and then dig three plastic expansion bolts holes on ceiling or other installation surface and then
insert three expansion bolts in the holes. Secure these three bolts firmly.
Note:
Please dig a “cable exit hole” in the surface according to the installation position map if you want to
draw out the cable from the top of the installation surface. You need to use the proper tool to open up
the side port of the U-cable channel of the dome camera pedestal if you want to draw out the cable
from the side port of the cable channel when you are installing the device cable. And then you can
draw out the cable from the cable channel of the pedestal.
Step 4
Adjust the device installation pedestal to the proper position and then draw the cable through the cable
exit you just dug in the ceiling (wall). Line up the TOP direction of the device to the installation position
map and then line up the three screw holes in the device pedestal to the three plastic expansion bolt
holes in the installation position. Put the three self-tapping screws in the three plastic expansion bolts
firmly. Now the dome camera is secure in the installation surface.
Step 5
Loosen the two M3 secure screws of the lens rotation structure (Do not remove, loosen a little bit will
be OK.). Use the inner hexagonal wrench to insert them to the inner hexagonal holes and then use the
wrench to turn the lens. Adjust the lens to the proper monitor angle and then secure the screws of the
lens rotation structure. The lens adjust angle ranges are: flip (0°~+75°), video pan rotation (-15°~+15°) ,
video rotation angle(-15°~+15°).
Step 6
Line up the dome camera cover to the cable exits and put the cover back. Use the inner hexagonal
wrench to secure the three inner hexagonal screws firmly. Now the installation completed.
Note:
The device GND cable can effectively enhance the device reliability. The GND hole is near the cable
exit of the back of the enclosure. The GND screw specification is M3. See Figure 3-3.
