Dahua HCVR82**A-S3 Series, User Manual

Page: 157 / 381

145

PTZ activation: Here you can set PTZ movement when an alarm occurs. Such as go to preset, tour
&pattern when there is an alarm. Click
“
select
”
button, you can see an interface is shown as in
Figure 4-135
X
.

Record Delay: System can delay the record for specified time after alarm ended. The value ranges
from 10s to 300s.

Tour: Here you can enable tour function when alarm occurs. System one-window tour.

Snapshot: You can enable this function to snapshot image when a motion detect alarm occurs.

Video matrix: Check the box here to enable this function. When an alarm occurs, VIDEO OUTPUT
port displays device video output. It displays video (1-window tour) from alarm activation channel
you select at the Record channel interface. It has high priority than the tour setup in Main
menu->Setting->System->Video matrix. Please note this function is for some series product only.

Buzzer: Highlight the icon to enable this function. The buzzer beeps when alarm occurs.

Log: Check the box here, system can record motion detect log.

Test: Click it to test current motion detect setup (do not need to save). Click Select button after
Region, you can set motion detect area.

Voice prompts: Check the box here to trigger audio broadcast function. You can select specified
audio file here. System can play the audio file once the corresponding event occurs.
Please highlight icon to select the corresponding function. After you completed all the setups,
please click Save button.
Note:
In motion detection mode, you can not use copy/paste to set channel setup since the video in each
channel may not be the same.
In Figure 4-134, you can left click mouse and then drag it to set a region for motion detection. Click Fn to
switch between arm/withdraw motion detection. After setting, click enter button to exit.
Figure
4-133
Figur
e 4-134