18
Destination MAC Address: The aggregation load balancing algorithm based on
destination MAC address.
IP Address: The aggregation load balancing algorithm based on source IPv4 address
and destination IPv4 address.
TCP/UDP Port: The aggregation load balancing algorithm based on source and
destination TCP/UDP port.
Select
Static
in the
Mode
area, and add the ports to the dynamic aggregation group. For
Step 3
example, add port 1 and port 2 to aggregation group.
Regarding 4-port PoE switch, at most 3 static aggregation groups can be set at the same
time. The static aggregation group is different depending on the models of switch. The
actual interface shall prevail.
Static configuration
Figure 3-11
Click
Save
.
Step 4
The port 1 and port 2 form a logical port.
3.1.4.2
LACP
LACP (Link Aggregation Control Protocol) is the protocol for link dynamic aggregation. LACP
communicates with another port through LACPDU (Link Aggregation Control Protocol Data Unit).
Select the port role from the drop-down list in
Mode
. There are two types:
Active
: The port can send LACPDU packet actively to the opposite port, and analyzes the LACP.
Passive
: The port cannot send LACPDU packet actively. After receiving the LACP packet sent by
the opposite port, the port analyzes the LACP.
Select
Advanced > Common > Aggregation
.
Step 1
