9
Figure 3-4
Step 1
Use the inner hexagonal wrench (provided) to loose the three inner hexagon screws in the
dome cover and then open the cover. See Figure 3-1.
Step 2
Use the inner hexagonal wrench (provided) to loose the three inner hexagon screws in the
dome and then remove the device installation pedestal. See Figure 3-2.
Step 3
Take out the installation location map from the accessories bag and then paste it on the ceiling
or the wall to identify the installation area. Draw out the cable exit and four plastic expansion
bolt holes in the installation position according to the device pedestal. Dig the four plastic
expansion bolt holes and cable exit. Insert the four plastic expansion bolts into the screw holes.
See Figure 3-3.
Step 4
Adjust the device installation pedestal to the proper position and then draw the cable through
the cable exit you just dug in the ceiling (wall). Line up the four screw holes in the device
pedestal to the four plastic expansion bolt holes in the installation position. Put the four self-
tapping screws in the four plastic expansion bolts firmly. See Figure 3-4.
Step 5
