Dahua ARC6416C series, User Manual

Page: 26 / 117

Figure 4-9
Step 3. Set parameter.
Parameter Note
Device Name Customize peripheral name.
Device Type Peripheral type supported by current device shall match device
type supported in protocol management.
Protocol Match peripheral one by one, the name of protocol is just
model of peripheral. Please see Ch 5.9.
Channel Type Physical port type of this peripheral.
Address Different port types, correspond to different addresses.
Relationships are
：
Channel type is local switch
（
Z1~Z16
）
, corresponding
address is 1~16.
Channel type is local analog value
（
A1~A8
），
corresponding
address is 1~8.
Channel type is RS485/RS232 port, corresponding address is
peripheral actual COM address.
Channel type is network, address by default.
NO/NC
Channel type is local switch quantity
（
Z1~Z16
）
, need to set
NO/NC according to peripheral type.
Analog Type
Channel type is local analog
（
A1~A8
）
, need to set current
type and voltage according to peripheral type.
Upper Limit Set according to actual peripheral.
Lower Limit Set according to actual peripheral.
Compensation
Value
When measure value and actual value differ, you can calibrate
via compensation value.
Chart 4-2