139
Parameter Function
Manual
Add
Click it, the interface is shown as in Figure 4-18. Here you can add
network camera manually.
You can select a channel from the dropdown list (Here only shows
disconnection channel.)
Note:
System supports manufactures such as Panasonic, Sony,
Dynacolor, Samsung, AXIS, Arecont, Dahua and Onvif standard
protocol.
If you do not input IP address here. System uses default IP
192.168.0.0 and system does not connect to this IP.
Can not add two devices at the same time. Click OK button here,
system only connect to the corresponding device of current
channel.
4.8.1.1.2 Upgrade
Important
This function is for online network camera only.
From main window->Setup->Camera->Remote device->Upgrade, you can see an interface is shown as
below. See Figure 4-19.
Check the network camera you want to upgrade and then click Browse button to select upgrade file.
Click Start upgrade button to begin the process.
Figure 4-19
Tips
You can use filter to select several network cameras at the same time.
4.8.1.2 Image
From main window->Setup->Camera->Image, you can see an interface shown as in Figure 4-20.
Here you can view device property information. The setups become valid immediately after you set.
Summary of Contents for 600 Series
