System Configurations
73
Analog (1)
Figure 4-73
Set the parameters. Refer to Table 4-13.
Step 2
Table 4-13 Analog keyboard parameter description
Parameter
Description
Connection mode
Set the connection mode, which only supports RS
–485 at present.
Device type
Enter device type.
Address
Enter device address.
Protocol
Select the protocol, including SD1, PELCOD and PELCOP.
AA-SD1 is the same as SD1, AA-PELCOD is the same as PELCOD, and
AA-PELCOP is the same as PELCOP. They are frequently-used
protocols; with AA- prefix, they are ranked in the front of the list.
Baud rate
Select baud rate.
Data bit
It includes 5, 6, 7 and 8.
Parity
It includes null, odd and even parity.
Stop bit
It includes 1, 1.5 and 2.
Click
OK
.
Step 3
Open PTZ control interface to carry out PTZ control. See Figure 4-74.
