12
1.
Apply the mounting template to the ceiling. Pre-drill the three perimeter holes for the expansion
bolts, using a drill bit that is no wider than the expansion bolt.
2. Drill the center hole (greater than 28 mm in diameter) to route the cable from the camera through
the installation medium.
3. Insert an expansion bolt into each pre-drilled perimeter hole.
4.
Align the three perimeter holes on the ceiling bracket with the three expansion bolts, then place
the ceiling bracket over the expansion bolts.
5. Secure the bracket to the expansion bolts using the three ST3 self-tapping screws.
6. Route the incoming wires through the installation medium and the ceiling bracket.
7. Make the proper power, video, Ethernet, alarm and audio connections.
8. Attach the waterproof network connector if the camera is used outdoors.
Figure 4-3
a. Place the wide side of the rubber ring onto the end of the network cable extending out from
the camera.
b. Pull the waterproof cable end without the Ethernet connector through the body of the
Waterproof Connector. Thread the cable through the Fixing Rubber Ring and the Waterproof
Locking Cover.
c. Attach the male Ethernet connector to the network cable coming from the camera. Ensure the
Waterproof Connector shroud covers the Ethernet connection.
d. Connect the other end of the waterproof connector to the network port and rotate it clockwise
to lock the network port and waterproof connector firmly.
e. Slide the Waterproof Locking Cover over the main body of waterproof connector and rotate it
clockwise to seal the connection.
9.
Align the gap on the camera body with the TOP if the ceiling bracket. Rotate the camera body
clockwise to secure the camera to the bracket and lock in place.
