11
10. Adjust the camera and the lens according to the application requirements of the location.
a) Loosen, but do not remove the set screws on either side of the bracket that holds the
camera.
b) Tilt the camera to adjust the tilt angle (0° to +75°). Tighten the two locking screws on the
bracket to lock the tilt angle.
c) Rotate the camera module to adjust image pan orientation (0° to +355°).
d) Place the dome cover over the camera to ensure that the cover does not obstruct the
camera.
Figure 4-3
11. Place the dome cover over the camera and align the holes on the cover to the holes and
pedestal. Insert a hex bolt into each hole and secure the cover to the pedestal with the hex
key.
12. Supply power to the camera.
Summary of Contents for N52BM5Z
Page 17: ...15...
