8
Step 1
Take out the installation position map from the accessories bag, and paste it on the ceiling or
wall
①
according to the cable outlet location, dig holes on the installation surface according to
the installation position map, take out the expansion bolts
②
from the accessories bag and
insert them into the installation holes and fix them.
Step 2
Use inner hex wrench
⑦
to loosen three locking screws
⑥
in the enclosure and take down the
enclosure
⑤
.
Step 3
Adjust the location of the dome pedestal
③
according to the top cable outlet or side cable
outlet. Pull the cable out through the side outlet of installation surface and pedestal (please
skip the step if it is top cable outlet), aim the screw fixing holes of dome pedestal to the fixing
holes of expansion boles on the installation surface, then insert the self-tapping screws
④
into
the expansion bolts and secure them firmly, fix the dome on the installation surface.
Step 4
Connect the video output port of the device to the back-end encoding device and connect the
power port to power.
Step 5
Adjust the lens angle to proper monitoring location after the image displays on the back-end
encoding device, and then adjust focal length of the lens to make image clear, which is shown
in Figure 4-2.
Figure 4-2
It can realize coaxial control via five-direction button for model A, which is shown in Figure 4-3.
