Web Configuration 16
6
Web Configuration
Web Introduction
6.1
The actual interface might be different dependent on the model you purchased and the version
of software. The figures in the Manual are only for reference, and the actual product shall
prevail.
6.1.1 First-time Login
Connect the Camera to network.
Step 1
1) Connect the Camera to PC over the Ethernet cable.
2) Keep the IP address of the PC and the camera on the same network segment.
The network segment can be set as 192.168.1.X, but cannot be the same with the
factory default IP of the Camera (192.168.1.108).
3) Execute ping ***.***. ***. *** (device IP) command on PC to check network
connection.
Enter the IP address of the Camera (192.168.1.108) in the browser address bar, and
Step 2
press Enter on the keyboard to login the web interface of the Camera.
The
Device Initialization
interface is displayed. See Figure 6-1.
Device initialization
Figure 6-1
Enter the new password. Select the Email Address check box, and then enter your
Step 3
email address.
Click
OK
.
Step 4
The
Login
interface is displayed. See Figure 6-2.
