User's Manual
10
5 Configuring Camera
You can configure the parameters of the strobe, flashlight and continuous light on the camera web
page.
The configuration page might vary with different web baseline. Select the corresponding
configuration.
5.1 Configuring External Light
Step 1
Log in to the camera web page and select
Setup
>
ITC
>
Extra Device
>
Light Config
.
Step 2
Configure the parameters of the flashlight or strobe.
Figure 5-1 Flashlight/strobe configuration
Table 5-1 Description of the flashlight/strobe parameters
Parameter
Description
Port
Select the external light type for each port between flashlight
and strobe.
Flashing Light
Work Mode
Forbidden: Flashlight stays off.
Always: Flashlight stays on.
Default: Configure the prevalue of brightness. When the
environment brightness is lower than the prevalue, the
flashlight lights up automatically.
Pulse Width
Set the pulse width value of the flashlight. When the
flashlight is configured as pulse width triggering, the pulse
width here needs to be inside the range of detection to
prevent false triggering.