4
Mounting the Doorbell to a Wall
Figure 2-1: DHI-DB11 Installation Schematic
Remove the M3x6 screw from the bottom of the unit, then remove the mounting bracket
from the underside of the doorbell.
Use the mounting bracket as a template to mark the position of the three (3) screw holes
and the hole for routing the wires.
Drill the holes in wall according to the template.
Insert the three (3) wall anchors into the pre-drilled screw holes.
Attach the mounting plate to the wall using the three (3) ST3x20 self-tapping screws.
Route the wires from the DHI-DB11 through the center hole.
Slide the doorbell down the mounting bracket from top to bottom.
Attach the doorbell to the mounting plate with the M3x6 screw on the underside of the unit.
Wiring the DHI-DB11 to a Doorbell Chime
The DHI-DB11 Video Doorbell connects directly to a mechanical or to an electric door chime
with the aid of the included DHI-DB11 Chime Kit. In general, the doorbell chime and the DHI-
DB11 are both connected to the AC power input and the transformer wire from the chime is
connected to the DHI-DB11 so that when a visitor pushes the DH-DB11 the chime plays the
tone.