Introduction 2
External Component Description
1.3
1.3.1
Front Panel
The front panel of the Switch consists of AC power connector, one marker, 1 x Reset button, a
series of LED indicators, 8 x 10/100/1000Mbps RJ-45 ports, 2 x SFP ports and 1x Console port
as shown as below.
Front panel
Figure 1-1
AC Power Connector:
Power is supplied through an external AC power adapter. It supports AC 100
–240V, 50/60Hz.
Grounding Terminal:
Located on the right side of the power supply connector, use wire grounding to lightning
protection.
Reset button (Reset):
Keep the device powered on and push a paper clip into the hole. Press down the button for 5
seconds to restore the Switch to its original factory default settings.
10/100/1000Mbps RJ-45 ports (1
–8):
Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each
has a corresponding Link/Act/Speed and PoE indicator.
SFP ports (9, 10):
Designed to install the SFP module and connect to the device with a bandwidth of 100Mbps or
1000Mbps. Each has a corresponding Link/Act/Speed LED.
Console port (Console):
Designed to connect with the serial port of a computer or terminal for monitoring and
configuring the Switch.
LED indicators:
The LED Indicators will allow you to monitor, diagnose and troubleshoot any potential problem
with the Switch, connection or attached devices.
The following chart shows the LED indicators of the Switch along with explanation of each
indicator.
Table 1-1 Front panel
LED
Indicator
Faceplate
Marker
Status
Indication
Power
Indicator
PWR
Off
Power Off
Solid green
Power On
