User’s Manual
51
Click
Save
.
Step 4
The multicast configuration of TS is similar to RTP, and you can refer to the previous steps.
4.2.10
802.1x
802.1x (port based network access control protocol) supports manual selection of authentication
method. Device can be connected to LAN after passing 802.1 x authentications. It well supports
authentication, charging, safety and management requirement of network.
Select
Setting > Network > 802.1x
.
Step 1
The
802.1x
interface is displayed. See Figure 4-33.
802.1x
Figure 4-33
Select
Enable
to enable 802.1x.
Step 2
Configure parameters. See Table 4-16.
Step 3
Table 4-16
802.1x parameter descriptions
Parameter
Description
Authentication
PEAP (protected EAP protocol).
Username
The username that was authenticated on the server.
Password
Corresponding password.
Click
Save
.
Step 4
4.2.11
QoS
You can solve problems such as network delay and congestion with this QoS (Quality of Service). It
helps to assure bandwidth, and reduce transmission delay, packet loss rate, and delay jitter to
improve service quality.
For DSCP (Differentiated Services Code Point), it has 64 degrees (0–63) of priority for packets; 0 is
the lowest and 63 is the highest. It can select different queues and the bandwidth of each queue
according to the priority. When the network is congested, bandwidth of different queues will be
discarded with different ratios so as to guarantee service quality.
Select
Setting > Network > QoS
.
Step 1
The
QoS
interface is displayed. See Figure 4-34.
