19
4.2.1 Configuring Protocol
If you want to control the external PTZ by the Camera, you need to set the PTZ protocol first and
then connect PTZ to the Camera.
Step 1
Select
Setting
>
System Management
>
PTZ Setting
.
Step 2
Configure PTZ parameters.
Figure 4-7 PTZ settings
Table 4-4 Parameter description
Parameter
Description
Protocol
Matches with the PTZ protocol.
Address
Enter the corresponding camera address.
The address must be the same with the address configured on the PTZ;
otherwise the Camera cannot control the PTZ.
Baud rate
Configure camera baud rate.
Data bit
It is 8 by default.
Stop bit
It is 1 by default.
Parity
It is None by default.
Step 3
Click
Save
.
4.2.2 Configuring PTZ Functions
●
The protocol setting has been completed. For details, see "4.2.1 Configuring Protocol".
●
View the image that represents the effect of external PTZ through the external PTZ, not the
Camera.
●
The following functions are available only when the Camera is connected to the external PTZ.
4.2.2.1 Configuring Preset
Preset means a certain position that the Camera can make quick orientation to. It includes PTZ pan